Warning Tactile Round Black Carborundum Infill - 316 Stainless Steel
Tap in CompFit
1 square metre would require 400 studs or an area at 900x600mm uses 216 studs
Use 8mm drill bit to create a hole in the floor and then tap in the tactile with a mallet.- Templates sold separately.
50 x Hazard Stainless Steel TGSIs, with spigot. Tap in nylon compression fitting - Stainless Steel Indicator Studs -
Tactile Ground Surface Indicators (TGSI)
1 square metre would require 400 studs or an area at 900x600mm uses 216 studs
Another Quality TGSI product from Advanced Group
INSTALLATION METHOD Tap-in CompFit Tactile indicators are installed into holes in the substrate pre-drilled with a suitable masonry or diamond tipped wet core drill bit. Tap-in CompFit Poly Tactiles are designed with a retention fit spigot and do not require adhesive. Due to the weakness of bitumen, it is suggested that polyurethane adhesive is injected into each hole to provide greater substrate stability and further secure the tactile spigot. When installing over carpet/underlay, a pre-drilled filler board is required as a replacement to the underlay.
The Tap-in CompFit Tactile range of tactile indicators are weather and UV stable and have a proven track record when safety and durability count.
* Please note that according to Australian Standards your tactiles need to have a 30% colour (luminance) contrast for TGSI tiles in contrast to your floor surface
To install to:
-Concrete
-Terazzo Stone
-Timber
-Ceramic tiles
-Granite
-Carpet
